Creality Falcon2 laser engraver honeycomb
8mm large-aperture honeycomb design contributes to faster heat dissipation and exhaustion of smoke, which prevents fire and your works from yellowing.
Additional information:
| Working area (engraving) | 500x500mm |
|---|---|
| Working area (cutting) | 456x456mm |
| Aluminum plate | 500x500x1.5mm |
There are two versions of honeycombs sold by Creality: a smaller one with 320x320mm, and this one, which is the bigger version with 500x500mm. This covers all the working area of the Creality Falcon 2 laser engraver.
A large aluminum plate of the same size of the honeycomb is also included in the box. That aluminum plate is supposed to be used underneath the honeycomb to prevent laser damage to the surface where the laser is being used (diode lasers can't engrave on aluminum - not without help anyway). This is especially helpful for when wood is being cut.
There's not much left to say about this honeycomb. It works well, covers the full working area and magnets stick to it. It's a must have if you have a Creality Falcon 2 laser.
You can see it in use in the following video:
